Off-Road Red C Hub Set for Tamiya DT-03 by JAZRIDER JR-DT304-RD  [JR-DT304-RD]

Tamiya DT-03 Aluminum C Hub (Red)
Price:
AUD$15.68
Brand:
JAZRIDER
Model:
JR-DT304-RD
Condition:
Brand New
Available in warehouse
Write a review

Red anodised C hubs to toughen the DT-03

The JAZRIDER red aluminium C hub gives the Tamiya DT-03 a more durable front end by replacing weak plastic hubs. The metal upgrade is aimed at hobbyists who want reliable steering under heavier loads.

Benefits over stock plastic

Aluminium offers consistent geometry and reduced wear, helping maintain predictable handling. The red anodise protects the surface and makes routine checks easier on busy builds.

Quick fit guide

Install with common hand tools and confirm that hub bolts are snug without over tightening. After installation, rotate the wheel to verify there is no binding and recheck alignment before a longer run.

Are extra shims required for wheel offset?

Most builds fit without extra shims, but certain wheel and tyre combinations can change offset. Measure clearance after fitting and add thin shims if needed.

Will these hubs add much weight?

Aluminium is heavier than plastic but the increase is small and offset by improved durability and stronger steering feedback.

Should I replace screws when upgrading?

Inspect the original screws; if they show wear or stripping, replace with correct grade hardware. Using thread locker on metal-to-metal joints can help hold settings.

Copyright © 2008-2025 rcjaz.com.au All rights reserved