Off-road favourite: JAZRIDER JR-DT305-RD Red Aluminum Servo Mount for Tamiya DT-03  [JR-DT305-RD]

Tamiya DT-03 Aluminum Servo Mount (Red)
Price:
AUD$11.25
Brand:
JAZRIDER
Model:
JR-DT305-RD
Condition:
Brand New
Available in warehouse
Write a review

Firm, reliable servo mounting for the Tamiya DT-03

The red JAZRIDER Aluminum Servo Mount provides a stronger fixing point for servos on the Tamiya DT-03. Made from solid aluminium, it replaces the less rigid plastic bracket and offers a dependable fit that helps keep steering precise over repeated use.

Aluminium advantages

Aluminium gives a good balance of low weight and increased stiffness. By swapping the stock plastic mount for the JAZRIDER unit you can expect reduced flex under load and a clearer steering feel, particularly on heavier servos or when running rough surfaces.

Fitting and upkeep

Fitment is straightforward with standard tools. Check that the servo horn is centred and that linkages move freely before driving. Periodic inspections of fasteners and pivot points will prevent loosening and preserve performance.

Is the mount compatible with high torque servos?

Yes, the aluminium mount handles higher loads better than plastic. Still confirm the servo case size and horn clearance to avoid interference.

Do I need special tools to install it?

No special tools are required. A set of screwdrivers and possibly a small hex driver for mounting screws are usually sufficient.

Will this change my servo alignment?

The mount maintains the intended servo position if installed correctly. Double check alignment during installation to keep steering geometry unchanged.

How often should I check the mount?

Inspect screws and linkage points after several runs and following any hard impacts. Regular checks help avoid play and keep steering precise.

Copyright © 2008-2025 rcjaz.com.au All rights reserved