TAMIYA DT-04 Rear Upper Arm 7075-T6 Alloy DT4057 by GPM  [DT4057]

TAMIYA DT-04 RC FIGHTER NXGEN 7075-T6 Alloy Rear Upper Suspension Arms - GPM DT4057
Price:
AUD$27.70
Brand:
GPM
Model:
DT4057
GTIN:
4894538407501
Condition:
Brand New
Write a review
alt="TAMIYA DT-04 RC FIGHTER NXGEN 7075-T6 Alloy Rear Upper Suspension Arms - GPM DT4057" title="TAMIYA DT-04 RC FIGHTER NXGEN 7075-T6 Alloy Rear Upper Suspension Arms - GPM DT4057"
alt="TAMIYA DT-04 RC FIGHTER NXGEN 7075-T6 Alloy Rear Upper Suspension Arms - GPM DT4057" title="TAMIYA DT-04 RC FIGHTER NXGEN 7075-T6 Alloy Rear Upper Suspension Arms - GPM DT4057"
alt="TAMIYA DT-04 RC FIGHTER NXGEN 7075-T6 Alloy Rear Upper Suspension Arms - GPM DT4057" title="TAMIYA DT-04 RC FIGHTER NXGEN 7075-T6 Alloy Rear Upper Suspension Arms - GPM DT4057"
alt="TAMIYA DT-04 RC FIGHTER NXGEN 7075-T6 Alloy Rear Upper Suspension Arms - GPM DT4057" title="TAMIYA DT-04 RC FIGHTER NXGEN 7075-T6 Alloy Rear Upper Suspension Arms - GPM DT4057"

Rear upper suspension arm in 7075-T6 aluminium for DT-04

This aftermarket rear upper suspension arm is a direct replacement tailored for the TAMIYA DT-04 RC FIGHTER NXGEN platform. Made from 7075-T6 aluminium to lower weight while increasing strength relative to original plastic components. The part is aimed at hobbyists seeking improved durability and steadier handling when adjusting setups.

The unit ships with the arm plus all required mounting hardware pre-installed for a simple swap into the stock rear upper arm location. We recommend using a medium-strength thread locker on the screws to maintain clamp security under vibration.

Packing includes

  • Rear Upper Suspension Arm - 2pcs
  • Stainless Steel Pins 3x26 - 2pcs
  • Stainless Steel Pins 3x19 - 2pcs
  • Grade 12.9 Black Round Head Screws 3x5 - 4pcs

Original Name / Part No:

10831

Compatible Models

  • TAMIYA 1/10 DT-04 RC FIGHTER NXGEN-58741

Fit this alloy arm to firm up rear response and replace damaged stock parts; check pin alignment on assembly and secure screws with medium-strength thread locker.

Will this replace the factory rear upper arm directly?

Yes. The arms are intended as a direct retrofit for the DT-04 rear upper suspension arm location on the RC FIGHTER NXGEN chassis.

Which fasteners come with the assembly?

Included are stainless pins in 3x26 and 3x19 lengths, plus four grade 12.9 black round head screws sized 3x5 to complete installation.

Any setup advice after fitting?

After fitting, confirm free movement of the suspension, check pin seating, and re-torque screws following the first run-in to ensure stability.

Does alloy increase impact resistance?

7075-T6 aluminium offers higher tensile strength and wear resistance than common plastics, which helps the arm sustain impacts and hold geometry under load.

Copyright © 2008-2026 rcjaz.com.au All rights reserved