TAMIYA F201 Rear Steering Unit TF201C-005 by 3Racing  [TF201C-005]

Rear steering unit overview

The TF201C-005 rear steering block is an RC-scale replacement made for the TAMIYA F201 platform by 3Racing. It installs where the rear steering linkages meet the hub carrier and is used to restore or tweak rear steering geometry without modifying the central chassis. Its position influences rear toe settings and steering feedback on the axle.

Installation notes: remove the hub carrier and linked parts, carry across any bearings or original fasteners, then mount the block with the stock screws. Minor trimming of surrounding plastic might be required if tolerances are off, but typically the block fits with original hardware. After fitting, check linkage free play and verify smooth steering across the full travel.

Tuning role: this hop-up is aimed at fine-tuning rear steering geometry for scale circuit setups. Adjusting block orientation or position will change rear toe-in and transient response, affecting corner entry and mid-corner balance. Make measured changes and validate with short test runs before committing to a setting.

Compatibility and caution: suitable for TAMIYA F201 style setups that use a rear steering block at the same mounts; always confirm fitment with your hub carrier prior to final assembly. This is a model part only and not suitable for full-scale vehicles.