Tamiya Front Stabilizer Holder for Thunder Dragon and Thunder Shot, Blue Aluminum - JR-TSD01-LB by Jazrider  [JR-TSD01-LB]

Tuning impact on steering and roll

This blue anodized aluminum front stabilizer holder is an RC replacement designed for Tamiya Thunder Dragon and Thunder Shot chassis. It provides a rigid mounting point for the stabilizer linkage, which improves repeatability when adjusting front roll and steering behaviour.

Because the holder reduces flex at the stabilizer attachment, it helps translate small setup changes into consistent handling differences. That consistency makes it easier to dial in steering feel and front-end balance during tuning sessions.

Installation notes: the unit installs in the front chassis area using the same mounting locations as the original holder on compatible Thunder Dragon and Thunder Shot assemblies. Depending on body and component layout, removal of the original piece or trimming of body panels may be necessary; typical RC workshop tools are adequate for the job.

Care and maintenance: while the anodized aluminum resists corrosion, inspect the mount after impacts for deformations and check fastening hardware regularly to preserve intended steering geometry.