Front Lower Aluminum Suspension Arms for TAMIYA Hotshot / Hotshot II / Boomerang 4WD JR-THS06-BK by Jazrider  [JR-THS06-BK]

Tamiya Hotshot, Hotshot II/2, Boomerang 4WD Aluminum Front Lower Suspension Arms (Black)
Price:
AUD$22.47
Brand:
JAZRIDER
Model:
JR-THS06-BK
Condition:
Brand New
Available in shop
Write a review

Replacement front lower suspension arms for TAMIYA

The JAZRIDER JR-THS06-BK front lower suspension arm is fabricated from aluminum for installation on TAMIYA Hotshot, Hotshot II/2, and Boomerang 4WD chassis. It serves as a direct replacement at the front lower mount and provides a metal upgrade where aluminum components are preferred.

Installation guidance: verify ball stud and hinge pin positioning during installation, confirm there is sufficient clearance with steering links and shock tower arrangement, and use the original mounting points unless the product listing specifies additional hardware. The unit is supplied with a black finish to match common chassis elements.

Specifications

  • Item: Aluminum front lower suspension arms (black)
  • Material: Aluminum
  • Model Number: JR-THS06-BK
  • Compatibility: Tamiya Hotshot, Hotshot II/2, Boomerang 4WD

Prior to final torque, confirm part orientation and that hardware seats correctly, then perform suspension alignment checks per your chassis routine.

How should I set up the suspension after fitting these arms?

Treat the arms as direct replacements, then recheck ride height, toe, and camber. Make small adjustments and test drive to fine tune handling.

Do these affect shock mounting or geometry?

They occupy the same front lower position; confirm shock eyelet clearance and any change in leverage before final setup.

Are there special tuning tips when switching to aluminum?

Aluminum can stiffen the suspension response slightly; you may want to soften springs or damping incrementally to restore preferred compliance.

Will steering throw be impacted?

Check full steering lock positions to ensure links do not contact the new arm; adjust link lengths or steering stops if necessary.

What is the correct part number?

This product is listed under model number JR-THS06-BK.

Should I reuse the original bolts?

If the original bolts match thread and length, reuse them; otherwise source matching hardware to avoid binding or misalignment.

Copyright © 2008-2026 rcjaz.com.au All rights reserved