Tamiya Hotshot/Bigwig/Boomerang Front Steering Knuckle - JR-THS01-BK by Jazrider  [JR-THS01-BK]

Tamiya Hotshot, Bigwig, Boomerang Aluminum Front Upright (Black) w/5mm Long Ball Connector
Price:
AUD$15.60
Brand:
JAZRIDER
Model:
JR-THS01-BK
Condition:
Brand New
Available in shop
Write a review

Steering knuckle upright for Hotshot, Bigwig and Boomerang

Designed for RC-scale use, this black aluminum front upright fits Tamiya Hotshot, Bigwig, and Boomerang chassis and comes with a 5mm long ball connector. It replaces the plastic knuckle to provide a metal connection point for steering and suspension linkages.

Use the aluminum upright to experiment with handling and to increase the rigidity of the steering assembly during tuning sessions. The included 5mm long ball connector should be checked against your vehicle's ball end spacing and mounting positions prior to installation.

Fitting tips: the upright secures into the front hub carrier and attaches to the steering rod with the long ball connector; basic hobby tools and careful alignment are all that is normally required. After installation, verify steering sweep and suspension droop to ensure free movement. This note applies to RC-scale model applications only.

Compatibility

  • Hotshot
  • Bigwig
  • Boomerang
An aluminum upright typically increases stiffness at the steering knuckle, which can make steering feel sharper; tune servo endpoints and ackermann if needed to balance response.
In many cases existing link lengths will fit, but confirm ball spacing and geometry. Small adjustments can fine-tune toe and steering behavior when switching materials.
Because the upright changes knuckle stiffness, expect subtle shifts in steering feedback and wear; re-evaluate shock settings and toe after fitting to achieve the desired handling balance.

Copyright © 2008-2026 rcjaz.com.au All rights reserved