Tamiya M03/M04M/M06 2 Degree Aluminium Rear Hub Carrier M04M-03/2/LB by 3Racing  [M04M-03/2/LB]

Price:
AUD$16.03
Brand:
3Racing
Model:
M04M-03/2/LB
Condition:
Brand New
Write a review

Aftermarket aluminium rear hub for Tamiya M03 line

The 3Racing aluminium rear hub carrier is made for Tamiya M03, M03L, M04M and M06 PRO chassis and provides a fixed 2 degree tuning option for rear geometry. It replaces the stock hub carrier and retains the original mounting points so the rest of the rear suspension remains compatible.

Build quality focuses on repeatable fit and resilience. The light blue anodised aluminium offers improved rigidity over plastic alternatives while keeping factory attachment locations for easy installation. The 2 degree orientation is intended for subtle tuning adjustments rather than large geometry changes.

Fitting advice: verify your chassis variant before ordering, remove the stock hub carrier and refit this unit using existing screws where appropriate, confirm there is no interference with the rear upright or wheel hex prior to final tightening, and adjust rear alignment after installation.

Compatible chassis

  • Tamiya M03
  • Tamiya M03L
  • Tamiya M04M
  • Tamiya M06 PRO

Can I reuse the original screws?

Yes, in most cases the vehicle's existing hardware can be reused. Inspect screws for wear and replace if necessary to ensure secure fastening.

Is the anodised finish durable?

The light blue anodised surface provides corrosion resistance and wear protection for everyday running, though like all finishes it can show wear under heavy use.

Should I change other suspension parts?

No other parts need changing for basic fitment. After installing the 2 degree carrier you may wish to fine tune shocks or toe to suit the new rear behaviour.

Copyright © 2008-2026 rcjaz.com.au All rights reserved