Tamiya M05 Rear End Graphite Stiffener 3Racing M05-07/WO Track Upgrade  [M05-07/WO]

Tamiya M05 Graphite Rear Suspension Pin Stiffener - 3RACING M05-07/WO
Price:
AUD$5.72
Brand:
3Racing
Model:
M05-07/WO
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Stiffen the Rear End on Your Tamiya M05

The 3Racing M05-07/WO Graphite Rear Suspension Pin Stiffener is a compact hop-up that reduces rear flex on the Tamiya M05 chassis. Built from quality graphite, the part helps the rear settle faster into turns and improves mid-corner balance.

Performance Advantages of Graphite Components

Graphite combines stiffness with low weight, which is useful when trimming lap times. Adding this stiffener tightens the chassis response so steering inputs translate more directly to tyre contact and grip consistency.

Installation and Setup Tips

Fitting the 3Racing M05-07/WO uses the stock rear pin positions on the M05 and requires common tools. After installation, recheck rear geometry and consider small changes to rebound or spring rate to match the increased chassis stiffness.

Is any trimming needed for installation?

Most stock M05 setups accept the stiffener without trimming; if you run bulky aftermarket parts near the mounting area, minor clearance work may be required.

Will it change corner entry feel?

Yes, expect a firmer rear response on entry and through mid-corner as the chassis resists twist more effectively. Adjust driving lines and setup accordingly.

Can I run this with stock shocks?

You can, but pairing the stiffener with slightly firmer damping or springs often yields the best handling balance.

Copyright © 2008-2025 rcjaz.com.au All rights reserved