Tamiya M05 Hub and Gearbox Bearing Set BS-M06PRO/V1 by 3Racing  [BS-M06PRO/V1]

Tamiya M05 Ball Bearing Set - 3RACING BS-M06PRO/V1
Price:
AUD$19.32
Brand:
3Racing
Model:
BS-M06PRO/V1
Condition:
Brand New
Write a review

Service bearings for the M05 chassis

This ball bearing set is offered as a replacement pack compatible with the Tamiya M05 chassis, written with practical fitment and maintenance advice for everyday hobby use. It explains how bearing replacement impacts driving feel during practice and tuning.

Installation notes: inspect axle journals, hub bores and gearbox seating for debris before pressing bearings in, use a proper bearing driver or a socket that matches the outer race to avoid introducing play, and check for free spin before final reassembly. For tight fits, warm the hub slightly and press bearings straight to avoid misalignment.

Setup and care: swapping worn bearings can reduce drivetrain drag and give a snappier throttle response and steadier steering on the M05. Keep bearings clean and apply light lubrication when servicing to preserve longevity and consistent handling.

Do these replace all M05 bearings?

They are intended to replace the common wheel and drivetrain bearings used on the M05, but verify sizes against your chassis before ordering.

Should hubs be heated if tight?

A slight warming of alloy or plastic hubs can ease insertion for tight fits, just avoid overheating and press straight to prevent misalignment.

How do I spot a bad bearing?

Listen and feel for roughness or binding when spinning the wheel by hand, and check for radial or axial play; replace bearings that feel gritty or loose.

Copyright © 2008-2026 rcjaz.com.au All rights reserved