Tamiya M06 Front Knuckle Arms Upgrade for Better Steering - M06-13000-LB by JAZRIDER  [M06-13000-LB]

Front knuckle arms in light blue anodized aluminum

This aluminium front knuckle arm set is intended for RC use on the Tamiya M06 chassis. The aluminium replacements stiffen the mounting point for the steering linkage and promote more consistent steering geometry when the car is under load.

Produced with a light blue anodized finish, the knuckles are focused on dimensional stability rather than altering the OEM geometry. They install as direct hop-up items for M06 steering gear and are suitable when a metal option is chosen to improve handling repeatability during setup and tuning.

When fitting the knuckles, transfer bearings and any required hardware from the original components and check ball stud alignment and steering arm clearance. Confirm steering throw and camber settings after installation and inspect thread engagement on mating fasteners to avoid damage.

Routine upkeep is limited to checking bearing seats and fastener torque. The anodized surface helps protect the metal, but inspect contact points after demanding runs or frequent adjustments.