Tamiya M08 On-Road Stiffener L Graphite - Factory Pro O-TCPM01L  [FP-O-TCPM01L]

Price:
AUD$20.04
Brand:
Factory Pro
Model:
FP-O-TCPM01L
Condition:
Brand New
Write a review

Graphite brace aimed at M08 setups

This Factory Pro part is a graphite chassis stiffener intended for Tamiya M08 use and marked for 239 compatibility, designed to tweak chassis flex without changing suspension geometry.

Focused on tuning, the stiffener raises local rigidity so the chassis transmits load differently between front and rear, which can improve turn-in and stability at speed for on-road layouts. It is made to work with the stock M08 mounting points and to complement adjustments to shocks, anti-roll bars and tyre choice.

Fitment is simple for anyone used to M08 servicing; the stiffener mounts to factory plate locations and usually replaces or supplements stock bracing. During assembly check fastener torque and alignment, and examine nearby screw holes and bearings for wear when you alter chassis stiffness.

Fit Notes

  • Tamiya M08
  • for 239

Will this stiffener suit club racing setups?

Yes, many racers add a stiffener like this to fine tune handling, but expect to adjust damping and roll bar rates after fitting.

Does the material add much weight?

Graphite provides stiffness with minimal weight gain, so it changes flex without significantly affecting overall mass.

Any special checks after installation?

After fitting, confirm torque settings and check surrounding mounting points and bearings for any signs of wear due to altered load paths.

Copyright © 2008-2026 rcjaz.com.au All rights reserved