TAMIYA M1025 Hummer Steering Tie Rod Upgrade 7pc HM160ST by GPM  [HM160ST]

Tamiya M1025 Hummer Spring Steel Completed Tie Rod-7pcs set - GPM HM160ST
Price:
AUD$18.18
Brand:
GPM
Model:
HM160ST
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Completed spring steel tie rod assemblies for TAMIYA M1025 Hummer

The 7pc completed tie rod pack is an aftermarket replacement for the TAMIYA M1025 Hummer RC, listed under GPM model HM160ST. Units are supplied finished and ready for direct installation on 1/10 electric chassis steering systems.

These parts are made to replace weaker plastic rods with spring steel links that better resist bending during normal hobby running. Pre-assembled tie rods reduce build time and are compatible with the typical steering knuckles and drag link layout found on M1025 Hummer kits.

Fitment notes: measure thread pitch and overall rod lengths before installation, use thread locker sparingly and only where service instructions advise, and verify steering geometry and toe after fitting. These components are for model RC use only.

Tuning notes: upgrading to spring steel assemblies tightens steering response and helps keep alignment after light impacts, assisting setup when adjusting toe and ackermann for tarmac or easy off-road tracks.

Does the kit come ready to fit?

Yes, the seven tie rods are completed assemblies intended for direct replacement of the M1025 Hummer steering links.

Can I use these on customised Tamiya builds?

They may be suitable for customised builds if thread sizes and steering arm positions match; always confirm measurements prior to fitting.

Recommended setup checks after fitting?

Check alignment, confirm steering throw, and avoid excessive torque on rod ends; apply thread locker only where periodic maintenance is acceptable.

Copyright © 2008-2026 rcjaz.com.au All rights reserved