Tamiya MF01X Aluminium Front Arm Upgrade MF055 by GPM  [MF055]

Tamiya MF01X Aluminium Front Suspension Arm - 1pr set (For MF01X / M06) - GPM MF055
Price:
AUD$27.05
Brand:
GPM
Model:
MF055
GTIN:
4894538021974
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="Tamiya MF01X Aluminium Front Suspension Arm - 1pr set (For MF01X / M06) - GPM MF055" title="Tamiya MF01X Aluminium Front Suspension Arm - 1pr set (For MF01X / M06) - GPM MF055"

Aftermarket aluminium front arm for MF01X/M06

This aluminium front suspension arm is offered by GPM as a replacement for Tamiya MF01X and compatible M06 layouts. The 1pr aluminium set is intended as a sturdier alternative to stock plastic arms, delivering improved repeatability and a longer service interval in regular use.

The arm follows the original MF01X / M06 mounting footprint for straightforward installation. In many cases the chassis' existing hardware will work, but always verify fastener compatibility and ensure proper thread engagement. After installation, inspect wheel alignment and perform a cautious test run.

Using aluminium arms typically increases front-end rigidity and can change chassis response at the limit. This upgrade suits modelers refining their setup; be prepared to retune spring and damper settings and check steering geometry after the swap.

Compatible Models

  • MF01X
  • M06

As a 1pr aluminium replacement item, GPM MF055 delivers a direct-fit metal option for MF01X and M06 front suspension tuning and maintenance applications.

Is this a bolt-on replacement for the stock arms?

Yes, it is made to the stock mounting pattern so it will bolt on to chassis sharing the MF01X/M06 points, subject to checking screw types.

Will using aluminium arms affect shocks?

Metal arms increase front stiffness, so you may need to fine tune shock damping or spring rates to restore intended handling balance.

Do I need threadlocker on the fasteners?

Using a medium-strength threadlocker on metal-to-metal fasteners is recommended to reduce the chance of screws backing out under vibration.

Can I use the original arm geometry settings?

Start with your original geometry and perform test runs, then tweak toe, camber and damping as needed since behaviour can shift with metal arms.

Copyright © 2008-2026 rcjaz.com.au All rights reserved