Tamiya MF01X Rear Suspension Knuckle MF022 by GPM  [MF022]

Tamiya MF01X Aluminium Rear Knuckle Arm - 1pr set - GPM MF022
Price:
AUD$26.31
Brand:
GPM
Model:
MF022
GTIN:
4894538042047
Condition:
Brand New
Write a review

Aluminium rear steering knuckle for MF01X

This aluminium rear knuckle arm is an aftermarket upgrade for Tamiya MF01X vehicles, supplied as a 1pr set to replace the factory plastic knuckles. It provides a metal mounting point aimed at improved durability and setup repeatability.

Switching to aluminium alters the stiffness and mass at the rear hubs, which can change how toe and camber react under load and give a firmer anchoring point for tuned rear suspension. It is intended to be a direct-fit alternative following MF01X layout dimensions.

Installation mirrors typical rear knuckle swaps on MF01X chassis: remove original hub carriers and fasteners, transfer bearings and pins, then fit the aluminium knuckle using the original screws and apply thread locking where necessary. Recheck wheel alignment and suspension travel before driving.

Specifications

  • Item: Rear knuckle arm, 1pr set
  • Material: Aluminium
  • Model Number: MF022
  • Compatibility: Tamiya MF01X

Ideal when you want a tougher rear hub mounting surface on your MF01X to help with consistent setup and improved longevity compared with stock plastic parts.

No chassis modification is normally required when fitted to a standard MF01X. Check for interference with suspension arms and test full steering lock after install.
Aluminium resists rust but can oxidise; keep contact surfaces clean and consider light corrosion protection if running in wet conditions.
Yes, the knuckle provides a firmer reference for setup changes, making small toe or camber adjustments more consistent during tuning.
Press bearings into the seat by hand or use a drift that only contacts the outer race, then spin to ensure smoothness and no play.

Copyright © 2008-2026 rcjaz.com.au All rights reserved