TAMIYA T3-01 Rear Fender and Hex Adapter Set +3mm T3333R by GPM  [T3333R]

Rear fender and wheel hex adapters

This kit supplies an aluminium rear fender and +3mm hex adapters made for the TAMIYA T3-01 DANCING RIDER chassis, designed to keep sand and small stones off the rear tyres while allowing a quick track-width tweak.

Parts are machined from 6061 T6 aluminium to maintain a low mass profile while providing adequate tensile strength for cosmetic protection and light-duty impacts. Hex adapters increase wheel hex thickness by +3mm compared with the original hexes to widen the rear track and alter handling balance for better straight-line stability.

Fitting to a T3-01 is simple: replace the stock plastic fender with the aluminium unit using the supplied stainless screws and washers, then swap the wheel hexes for the +3mm adapters. No extra machining of rims or hubs should be required when your wheels accept standard hex adapters of matching outer diameter.

A practical upgrade for recreational off-road use where light protection and a wider rear stance help handling; inspect fit and clearances after initial runs.