TAMIYA T3-01 Stainless Rear Shaft with Aluminium Hex +2mm Upgrade - T3023SR/+2MM by GPM  [T3023SR/+2MM]

Rear shaft and hex adapter upgrade for T3-01

This aftermarket kit replaces the factory rear drive parts on the TAMIYA T3-01 DANCING RIDER with a stainless steel shaft and aluminium hex adapters, aimed at hobbyists tuning driveline reliability. The set transfers power from the rear gearbox to the wheels while adding a 2mm track increase at each side when installed.

The single-piece stainless shaft delivers better resistance to bending and wear than thin stock components, and the aluminium hex adapters fit standard wheel hubs. The kit is supplied with screw shafts and stainless locknuts to secure the assembly and reduce drivetrain play.

Installation: the shaft mates with the chassis rear gearbox output and standard T3-01 wheel hubs. Clean threads before installation, use the supplied screws and locknuts to set preload, and check wheel runout after mounting and again after a short drive.

Tuning note: use this set to firm up the rear driveline connection and apply a modest track change for handling tweaks; it is appropriate for hobby-scale setup changes on the T3-01 platform.

Choose this set when you want a tougher direct replacement for rear drive shafts and a small +2mm track adjustment; re-tighten and inspect fasteners after the initial test runs.