This aluminum front suspension mount set is an aftermarket upgrade intended for the TAMIYA TA07 chassis, presented in a gun metal finish. It replaces or supports the OEM mounting points to provide a stiffer connection for the front suspension tower, which can enhance steering response and suspension articulation during dynamic use.
Installation follows familiar TA07 service steps: remove the stock front mount, carry over any usable bearings and screws, fit the aluminum mount to the chassis using the original screw bosses, and check chassis alignment prior to any test runs. Standard hex tools are adequate; inspect screw lengths and thread engagement to prevent chassis stress.
When dialing in the car on the bench, the mount helps maintain consistent camber and caster under load so tuning changes behave more predictably. Apply incremental setup changes and perform short validation runs to confirm handling improvements.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
