JAZRIDER JR-TFD12-RD Red aluminium Rear Guard - Tamiya Thunder Shot, Fire Dragon fit  [JR-TFD12-RD]

Tamiya Thunder shot/ Thunder Dragon/ Fire Dragon/ Terra Scorcher Aluminum Rear Guard (Red)
Price:
AUD$15.15
Brand:
JAZRIDER
Model:
JR-TFD12-RD
Condition:
Brand New
Available in warehouse
Write a review

Rear bash protection for Tamiya buggies

The JAZRIDER Aluminum Rear Guard adds dependable rear-end protection for Tamiya Thunder Shot, Thunder Dragon, Fire Dragon and Terra Scorcher models. The red anodised panel helps shield the chassis and rear body mounts during rough off-road sessions.

Where it fits and what to expect

Engineered to match common rear mounting points on several Tamiya kits, this guard offers a secure fit with minimal modifications. It is a practical upgrade for weekend drivers and club racers alike.

Practical installation notes

Ensure screws are tightened in a cross pattern and check clearance with your body shell. Using standard RC tools and a small amount of thread locker will keep the guard stable under load.

Is trimming the chassis required?

No trimming is usually required for the listed Tamiya models, but if you run non-standard rear cages check for interference before final mounting.

Can I use this on a race setup?

Yes, it is suitable for track or off-road use. Racers should verify weight and balance impacts when tuning their setup.

How do I protect the finish?

Clean with mild soap and water after muddy runs and avoid abrasive cleaners. Inspect mounting hardware regularly and replace any damaged screws.

Copyright © 2008-2025 rcjaz.com.au All rights reserved