Tamiya TRF 416 Compatible Differential Bearing Housing 416-10D by 3Racing  [416-10D]

Diff bearing housing compatible with TRF 416

This component is a direct-fit replacement intended for Tamiya TRF 416 differential assemblies, fitting into the original mounting position to make installation straightforward for hobbyists and racers.

To install, follow the normal diff service routine: remove the differential from the chassis, split the diff case, replace the housing, then reassemble while verifying bearings are seated correctly and aligned. Keep the original screw layout and TRF 416 torque recommendations when tightening.

In tuning, the housing maintains bearing and gear alignment under drive loads; consistent seating and accurate clearances help prevent premature wear and keep diff action predictable during throttle and steering transitions on 1/10 race setups.