Tamiya TRF421X Front Bumper Upper Plate O-TCP013 - Graphite by Factory Pro  [FP-O-TCP013]

Factory Pro FP-O-TCP013 Tamiya TRF421X - Bumper Upper Plate - Graphite
Price:
AUD$15.79
Brand:
Factory Pro
Model:
FP-O-TCP013
Condition:
Brand New
Write a review

Front bumper reinforcement for TRF421X

The Factory Pro FP-O-TCP013 is an aftermarket graphite top plate designed for the Tamiya TRF421X chassis. It replaces the stock upper bumper element and secures to the original TRF421X mounting points.

Using graphite lowers local compliance at the bumper mount while keeping weight minimal, which helps produce a quicker front-end reaction to steering inputs. The plate modifies how impact loads and chassis torsion are shared across the front assembly.

Installation uses the TRF421X factory screw pattern and stock hardware. When fitting the plate, line it up with the bumper mounts before final tightening, avoid excessive torque around composite parts, and verify the plate does not interfere with the servo or suspension across full travel.

Setup guidance: swapping in this stiffer graphite plate typically tightens turn-in and can reduce high-frequency bounce; evaluate changes by testing small increments in caster and damper settings to achieve the desired handling.

How will the FP-O-TCP013 alter steering characteristics?

Expect a crisper steering feel and quicker initial response due to increased stiffness at the bumper mounts; this can improve turn-in but may require small suspension tweaks to balance grip.

What setup changes pair well with the graphite plate?

Start with modest increases in front damping or a slight caster tweak to control the sharper steering; make one adjustment at a time and evaluate lap-to-lap changes.

Should I test changes on low- or high-grip surfaces first?

Try the plate on a high-grip surface first to assess reductions in chatter and the sharper steering feel, then tune down for lower grip if needed.

Copyright © 2008-2026 rcjaz.com.au All rights reserved