Tamiya TRF421X Graphite Rear Body Post Mount Plate - FP-O-TCP014 by Factory Pro  [FP-O-TCP014]

Factory Pro FP-O-TCP014 Tamiya TRF421X - Rear Body Post Mount Plate - Graphite
Price:
AUD$15.79
Brand:
Factory Pro
Model:
FP-O-TCP014
Condition:
Brand New
Write a review

Installation-focused rear body mount for TRF421X

This rear body post mount plate is made for the Tamiya TRF421X platform and is identified as Factory Pro FP-O-TCP014. Machined graphite provides a firmer interface than typical plastic mounts, which helps control small movements where the rear body attaches to the chassis.

The component secures the rear body posts and supplies a consistent seating surface that assists with repeatable body positioning when you change mounting points. Reducing unwanted play at the mount helps keep aerodynamic and chassis behaviour steady during setup adjustments.

Installation is aimed at experienced modellers: the plate fits the TRF421X rear body post area and should use the chassis' existing holes and fasteners. Test fit and confirm body clearance and movement before finishing the assembly to ensure nothing binds.

What steps do I follow to install this plate on a TRF421X?

Remove the existing body post area hardware, position the graphite plate over the rear post interface, then refit the original fasteners and torque to a safe value. Confirm alignment and body clearance before final tightening.

Do I need special screws or can I reuse my stock hardware?

In many cases you can reuse the TRF421X body post hardware. If the supplier does not include screws, match the thread and length to the chassis fasteners to avoid interference with body travel.

Will this change how my body mounts sit relative to the chassis?

The plate is intended to maintain the original mounting relationships while reducing flex. After installation, recheck body position and throw to ensure the mount sits as expected.

Copyright © 2008-2026 rcjaz.com.au All rights reserved