TAMIYA TT01 Alloy 31mm Dog Bone Front and Rear TT131 by GPM  [TT131]

Durable 31mm dog bone for TT01 use

This aftermarket 31mm alloy dog bone is made for the TAMIYA TT01 chassis and supplied as a front/rear driveshaft for hobby use only. It replaces the TT01 factory dog bones where a metal upgrade is wanted for maintenance or circuit runs.

A front/rear dog bone on the TT01 transfers power from the gearbox output shaft to the hub carriers while allowing suspension movement. Choosing an alloy dog bone retains correct TT01 fitment and geometry and focuses on resisting wear under standard touring car loads.

The part fits directly into TT01 dog bone positions: remove the original unit, inspect pins and bearings, seat the alloy dog bone correctly, and confirm full articulation through suspension travel. Re-check alignment and tighten fixings before driving.