Tamiya TT01 Front Damper Plate with Gearbox and Screws TT028 by GPM  [TT028]

Tamiya TT01 Alloy Front Damper Plate With Gear Box & Screws - GPM TT028
Price:
AUD$36.33
Brand:
GPM
Model:
TT028
GTIN:
4894538211894
Condition:
Brand New
Write a review

Front damper plate replacement for TT01

This alloy front damper plate is an aftermarket RC scale part made for the Tamiya TT01 chassis, combining the front damper top mounts and a gearbox mounting interface into one piece. The unit is aimed at improving robustness and simplifying front-end rebuilds while keeping the TT01 mounting arrangement.

The plate is produced from alloy to preserve rigidity at the junction of damper tops and the gearbox interface. The package contains the necessary screws to fix the plate and locate the gearbox, letting hobbyists swap out the stock plastic component for a metal version during maintenance or setup changes.

Installation notes: it fits to the existing TT01 front bulkhead and suspension mounting points, so front disassembly is needed. Confirm gear mesh and thread engagement when attaching the gearbox to prevent binding. Typical RC hand tools, including a hex driver set, will cover the job.

Specifications

  • Item: Front damper plate with gear box and screws
  • Material: Alloy
  • Model Number: TT028
  • Compatibility: Tamiya TT01

Ideal when you require a metal front damper mounting solution for the TT01 or when consolidating gearbox mounting during front-end service; always check fit and gear alignment after installation.

Is reinforcement necessary when using this plate?

The alloy plate itself strengthens the front mounting area, so extra reinforcement is usually not required unless you run extreme loads. Inspect mounting points and hardware for secure fit.

Will the supplied screws work with aftermarket bulkheads?

Screw compatibility depends on the aftermarket bulkhead dimensions. If your bulkhead uses different thickness or thread engagement, you may need alternate screws to match depth and avoid interference.

Does this plate include any bearings or gears?

The kit is a mounting plate with a gearbox interface and fasteners; it does not include internal gearbox parts like gears or bearings unless listed separately by the seller.

How should I check gear mesh after install?

With the gearbox temporarily fitted, rotate the input to observe mesh across the gears, then make small adjustment shims or reposition until smooth engagement is achieved before final torque.

Copyright © 2008-2026 rcjaz.com.au All rights reserved