TAMIYA TT-02 High-Strength Aluminum Outer Joint Red TT02-13104-RD by Jazrider  [TT02-13104-RD]

Tamiya TT-02 Aluminum Differential Outer Joint (Red)
Price:
AUD$6.98
Brand:
JAZRIDER
Model:
TT02-13104-RD
Condition:
Brand New
Available in shop
Write a review

High-strength aluminum outer joint for TT-02

This aluminum differential outer joint is made for the TAMIYA TT-02 platform and carries the part number TT02-13104-RD. The red anodized aluminum replaces the typical plastic outer cup to give a firmer coupling at the differential output, reducing compliance under load for a more direct driveline feel.

Installation follows common differential servicing: disassemble the housing, remove the original outer cup, install the aluminum outer joint onto the differential output stub, check rotational freedom and clearance, then reassemble. Verify mating surfaces and fasteners are correct before testing.

In tuning use this component to adjust driveline feedback and wear behavior; the stiffer joint alters load transfer across the differential so check gear mesh, lubrication, and monitor for play as part of your initial tuning cycle.

Will this change how the car feels on corner exit?

Yes, the stiffer outer joint can sharpen driveline response and slightly change traction transfer; tune differentials and gear mesh accordingly to match handling goals.

Should I alter differential oil after fitting?

Not necessarily, but inspect oil condition and consider minor viscosity changes if you want to tune spin and engagement characteristics after fitting the aluminum joint.

Does the joint affect wear on drive shafts?

By reducing flex at the output, the joint can alter load on drive shafts; monitor shaft ends and couplers during the first few runs to check for any unexpected wear.

Copyright © 2008-2026 rcjaz.com.au All rights reserved