TAMIYA TT-02B/DF-02 Rear Knuckle Arms Aluminum Upgrade for Tuning - JR-TT2B03-BK by Jazrider  [JR-TT2B03-BK]

Tamiya TT-02B / DF-02 Aluminum Rear Knuckle Arms (Black)
Price:
AUD$15.96
Brand:
JAZRIDER
Model:
JR-TT2B03-BK
Condition:
Brand New
Available in shop
Write a review

Rear Knuckle Arm Upgrade for TAMIYA TT-02B/DF-02

This aluminum rear knuckle arm is an RC-scale spare part intended for use on TAMIYA TT-02B and DF-02 chassis, listed as model JR-TT2B03-BK. It provides a metal substitute for the original plastic arm to give a firmer pivot point and more predictable setup behavior during tuning.

The item targets rear suspension and steering link geometry where reduced flex can change camber and toe under load; use it as part of a handling setup strategy to achieve steadier rear traction and repeatable adjustments.

Installation notes: built for the rear knuckle arm location on the specified chassis. Use the vehicle manual for correct removal and fitting steps, confirm correct fit and alignment, then recheck fastener security after a short run session.

Compatibility

Compatible with Tamiya TT-02B and DF-02 chassis as identified in the product name.

How will this affect my rear-end tuning?

Expect a firmer rear mounting point which can reduce unwanted flex and make camber and toe changes more consistent when adjusting suspension settings.

Should I change other suspension parts when fitting this?

It is common to reassess rear dampers and anti-roll settings after fitting stiffer knuckles to keep balance between front and rear handling.

Is special setup required for JR-TT2B03-BK?

No unique setup is mandatory, but test runs and incremental adjustments will reveal the handling differences introduced by the aluminum arms.

Copyright © 2008-2026 rcjaz.com.au All rights reserved