Tamiya WR01/WT01 Shock Tower Upgrade for Tuning JR-WR101-LB by Jazrider  [JR-WR101-LB]

Tuning benefits and setup for WR01/WT01

This 1pc aluminum front/rear shock tower is made as an RC-scale replacement part for Tamiya WR01 and WT01 chassis, finished in light blue anodized color. It is intended to provide a stiffer mounting point compared with typical plastic towers and to serve as a stable reference when adjusting shock position and overall suspension behaviour.

Replace the original tower to gain a consistent mounting plane that makes comparing shock positions and spring/damper combinations simpler. The JAZRIDER tower changes the anchor stiffness which can alter shock travel characteristics and camber behavior under load, so small adjustments to valving and spring rate may be required when switching to the aluminum part.

For tuning sessions: make incremental changes, record the shock position used, and test on the same surface to isolate the tower's effect. Always recheck fastener tightness after the first run and verify there is no interference with servo horns or suspension link motion.