Tamiya WT-01N Off-Road Steel Rear CVD Shaft GPM WTN2238C129 [WTN2238C129]

Tamiya WT-01N Steel Rear CVD Shaft (38mm) With 12x9mm Hex Adapter - 1pr set - GPM WTN2238C129

Price:

AUD$29.86

Brand:

GPM

Model:

WTN2238C129

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Tamiya - Monster Trucks

Built tough steel rear CVDs for hard running WT-01N

Fit these steel rear CVD shafts to a Tamiya WT-01N to cut down on breakages when tackling rough tracks. The 38mm axle length and 12x9mm hex adapter secure the wheel connection and withstand heavier loads than stock plastic parts.

Packing includes

Steel Rear CVD Shaft (38mm) - 1 pair
12x9mm Hex Adapter - 1 pair

Compatible Models

Tamiya WT-01N

Will these handle wet and muddy conditions?

Yes, steel shafts tolerate wet and muddy environments better than softer materials, though periodic cleaning will extend service life.

Do I need to change driveline tuning after fitting?

No major setup changes are required; check hub tightness and alignment after install and carry out a short test run.

Are these suited to higher power motors?

Steel shafts are a better match for higher torque setups than standard plastic parts, helping reduce driveline failures under load.