Team Associated RC18T 55T/57T/59T Plastic Spur Gear Set RC18-031 by 3Racing  [RC18-031]

Team Associated RC18T Plastic Spur Gear Set ( 3 Pcs - 55T/57T/59T ) - 3RACING RC18-031
Price:
AUD$7.01
Brand:
3Racing
Model:
RC18-031
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Trackside spur gear options for RC18T

The 3-piece plastic spur set includes 55T, 57T and 59T gears to let you fine tune the drive ratio on Team Associated RC18T electric models. Switching between these tooth counts lets you dial in quicker acceleration or a higher top speed without changing the pinion gear.

Installation is simple: remove the gearbox access plate, swap the spur onto the gearbox shaft, check pinion engagement and fasten with the stock retainers. Re-check mesh under a light load and retighten chassis screws to factory torque so the gears run true. Keep the original shims or washer stack to retain proper mesh alignment.

Carry this kit as spares for on-field repairs or setup changes. Inspect for wear after extended use and replace any gear with damaged or rounded teeth. These spurs are intended for hobby electric RC drivetrains only.

Can I use these with my current pinion?

Yes, they are designed to work with your existing pinion but you must verify and adjust mesh for each spur change.

How should I check mesh after fitting?

Set a slight mesh, run the drivetrain by hand, then test under light motor load and re-torque fasteners to ensure no binding or skipping.

What signs show a spur needs replacing?

Look for chipped teeth, rounded profiles, or irregular wear patterns; any of these warrant replacement to avoid drivetrain damage.

Copyright © 2008-2026 rcjaz.com.au All rights reserved