Team Powers TP-Radon-SW-80 Radon Series 80mm Sensor Wire  [TP-Radon-SW-80]

Radon Series 80mm Sensor Wire Details

This Radon Series signal wire serves as a dedicated sensor lead for sensored brushless motor to ESC signal connections in RC models. The 80mm length is chosen to suit common internal routing without excess cable.

Fit the wire by following existing harness channels, avoid routing across power cables, and secure it with shrink tubing or small ties where the run passes constrained areas. You may solder the conductor or use a compatible connector where terminals permit; always reinstate insulation and provide strain relief after making the connection.

To keep feedback consistent during setup and use, run the sensor cable as directly as possible, verify pin alignment before final assembly, and prevent sharp bends at solder points. Correct routing and secure fixing preserve sensor accuracy under load.