Throttle Linkage Servo Arm for SRX8 Gen4 GP - Serpent 601380  [SER601380]

Servo arm design and function

The Serpent 601380 servo lever throttle functions as a direct replacement for the servo-to-throttle linkage on Serpent SRX8 Gen4 GP (SER600024) models. It provides a solid pivot and mounting point for setting servo travel and throttle geometry.

To install: remove the original arm, align the replacement on the servo spline at your selected neutral, tighten the retaining screw, then attach the throttle linkage and test for smooth travel. Always re-check transmitter centering and end points before full use.

When tuning, remember the lever changes leverage and linkage geometry; small shifts in position or arm length will alter sensitivity and maximum travel. Adjust gradually and inspect for any binding at the extremes of motion.