Throttle/Brake Nylon Link Set for SRX8 Gen4 - Serpent 601360  [SER601360]

SRX8 Gen4 linkage nylon kit overview

This Serpent 601360 throttle linkage nylon set is an RC-scale replacement kit built for the SRX8 Gen4 chassis. The parts are intended to replace worn plastic pivots along the throttle and brake link paths, restoring smooth articulation and reducing unwanted free play.

Fitment is focused on SRX8 Gen4 layouts; verify each component against your chassis before fitting. Molded nylon gives a practical compromise between wear resistance and enough compliance to tolerate impacts without stressing metal linkages.

Installation follows a basic procedure: remove the degraded linkage pieces from the servo arm and throttle/brake lever, transfer or fit the required retainers and pins, then check that the linkage moves across its full range without binding. After installation, confirm neutral centring and adjust transmitter endpoints as necessary to recover correct throttle and brake behaviour.

For ongoing upkeep, treat the set as a scheduled maintenance item. Inspect parts after heavy sessions and replace any items that show deformation, increased play, or rough pivots. Maintain clean pivot areas and use a light specialist lubricant on metal-to-plastic contact points when appropriate.