Tomahawk 85 WC Arm Shaft Block Pair Kyosho SCW032  [KY-SCW032]

Arm Shaft Block CNC Replacement for Tomahawk

This Kyosho SCW032 CNC Arm Shaft Block2 is supplied as a two-piece replacement specifically referenced for Tomahawk 85 WC and listed for use on Scorpion Series variants. It acts as the pivot block in the arm assembly and is packaged as 2pcs for repair or spare use.

Role and benefits: the block secures the arm pivot shaft to reduce lateral movement and restore tighter axle geometry. As a CNC-produced component, it is intended for maintenance cycles or component swaps where pivot slop impacts handling.

Fitting guidance: the block seats into the original arm location and typically uses the vehicle's stock hardware for fastening. A basic RC toolset and attention to fastener condition are recommended when refitting.

Setup influence: installing a new arm shaft block can sharpen steering consistency and stabilize suspension response by removing excessive play at the pivot point; consider it when troubleshooting steering vagueness.

Install Kyosho SCW032 to bring pivot accuracy back to Tomahawk 85 WC vehicles or when a direct-fit service replacement is required for Scorpion Series models.