TRAXXAS 1/10 Slash 4x4 Off-Road Alloy Motor Mount SLA018A by GPM  [SLA018A]

Rigid alloy mount for Slash 4x4

The SLA018A alloy motor mount is an aftermarket one-piece replacement tailored for TRAXXAS 1/10 Slash 4x4 vehicles. It secures the motor and helps hold motor-to-pinion alignment steady under load. The alloy construction reduces flex compared with stock plastic mounts, which supports consistent mesh and more reliable throttle input during setup and rough driving.

This component is focused on compatibility with TRAXXAS 1/10 Slash 4x4 layouts; check the bolt pattern and shaft position relative to your gearbox and motor plate to confirm fit. It is useful when you need a stiffer mounting interface or are replacing a damaged factory part.

Installation follows standard Slash 4x4 procedures, but take time to align the motor correctly. Make sure the motor face is parallel to the spur, establish a small, even amount of backlash on the pinion, and ensure the mount does not impinge on ESC wiring or chassis supports. Regular checks after running will catch any loosening or mesh drift.

A straightforward aftermarket upgrade for Slash 4x4 drivers who want a firmer motor mounting solution for setup and tuning tasks, supplied as a single piece by GPM SLA018A.