TRAXXAS 1/18 Latrax Rally Rear Arm Bulk - Aluminium LTX009 by GPM  [LTX009]

TRAXXAS 1/18 Latrax Rally Aluminium Rear Arm Bulk - 1pc - GPM LTX009
Price:
AUD$14.17
Brand:
GPM
Model:
LTX009
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Sturdy aluminium rear arm bulk for 1/18 Latrax Rally

This aftermarket aluminium rear arm bulk is compatible with the TRAXXAS 1/18 Latrax Rally and supplied as 1pcs. It replaces the original plastic rear arm bulk to give improved resistance to wear while retaining factory mounting points for simple installation.

To install: remove the stock rear arm bulk, transfer any required linkage hardware and bearings, align the aluminium part in the correct orientation and secure it using the original mounting screws. After fitting, check that fasteners are seated correctly and that suspension linkages move without binding.

Fitting an aluminium bulk affects rear suspension attachment stiffness and can influence tuning choices such as shock preload and rear toe. Treat this item as an aftermarket RC replacement and confirm model compatibility prior to purchase.

Will the aluminium cause extra wear on mating parts?

Aluminium can change contact characteristics versus plastic; inspect link pins and bearings after a few runs and replace worn items if needed.

Can I paint or anodise this part?

Surface finishing is possible but follow paint or coating instructions suitable for aluminium and ensure all mounting faces remain flat and clean during the process.

Is this sold with screws or bearings?

The part is sold as 1pcs and normally uses existing screws and bearings from the original assembly, so retain those when removing the old unit.

Copyright © 2008-2026 rcjaz.com.au All rights reserved