TRAXXAS 1/8 X-Maxx 22mm Anodized Aluminium Cone Lockers TXM005N by GPM  [TXM005N]

TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N
Price:
AUD$31.25
Brand:
GPM
Model:
TXM005N
GTIN:
4894538036565
Condition:
Brand New
Write a review
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"

Aftermarket cone lockers for X-Maxx

This aluminium cone wheel locker serves as an aftermarket replacement for TRAXXAS 1/8 X-Maxx platforms. The tapered profile centers and compresses the wheel assembly against the hub to help maintain seating under demanding off-road conditions.

The part comes as a set of four, sized for a 22mm wheel hex interface, and finished in anodized aluminium for corrosion resistance and consistent mating. Installation is straightforward on compatible X-Maxx hubs and does not normally require hub modification.

Specifications

  • Item: Wheel Cone Locker, 22mm, 4pcs
  • Material: Aluminium
  • Model Number: TXM005N
  • Compatibility: TRAXXAS 1/8 X-Maxx

These aluminium cone lockers are a practical upgrade from plastic retainers when you want repeatable wheel preload and a corrosion-resistant finish for TRAXXAS X-Maxx models.

This item is compatible with

  • TRAXXAS XMAXX
  • TRAXXAS X MAXX 8S Monster Truck

Are these compatible with X-Maxx hubs out of the box?

Yes, they are made for the 22mm wheel hex interface found on TRAXXAS 1/8 X-Maxx hubs. Confirm your hub type if you run custom hexes or adapters.

Do I need to alter the hub to fit these cones?

No hub modification should be required; the cones are shaped to match common X-Maxx wheel geometry. Fit and check for correct seating before completing a full run.

What maintenance is recommended?

Keep mating surfaces clean and free of grit, rinse after wet runs, and inspect for damage. Replace any cones that show significant wear or deformation.

Will anodized cones change wheel balance?

The small mass difference is unlikely to affect wheel balance in normal use. If you run high-precision setups, balance wheels after installation as part of final checks.

Copyright © 2008-2026 rcjaz.com.au All rights reserved