TRAXXAS 1/8 X-Maxx Front and Rear Lower Arms Aluminium TXM055F/R by GPM  [TXM055F/R]

This aftermarket pair replaces the OEM lower arms on 1/8 scale TRAXXAS X-Maxx platforms, offering a machined aluminium alternative to the original plastic parts. The components are intended to maintain the original mounting layout while providing a firmer suspension link option.

Fit and installation: arms come as a matched front and rear set ready to swap with the factory pieces. Remove the wheel and hub assemblies, transfer any needed pins or spacers from the originals, and fit the new arms with the same mounting hardware. After fitting, check hinge-pin alignment and steering geometry to prevent binding and ensure correct movement.

Tuning role and setup notes: aluminium lowers reduce arm flex compared with stock plastic, which can alter shock and toe behaviour. Reassess ride height and adjust shock preload or link positions as needed to dial in handling. Inspect adjacent components such as hinge pins and ball studs for accelerated wear after conversion.

Durability and service: the aluminium construction resists bending but can shift loads into suspension pins and mounts; schedule periodic inspections of mating hardware. These arms are intended for off-road RC use and should be installed by those familiar with X-Maxx suspension layouts.

This item is compatible with

• TRAXXAS XMAXX