TRAXXAS 4WD GT4 TEC 2.0 Aluminium Front/Rear Brake Disk and Caliper Kit GT006AB by GPM  [GT006AB]

Front and rear aluminium brake disk kit

This aluminium brake disk and caliper kit is crafted as an aftermarket replacement for the TRAXXAS 4WD GT4 TEC 2.0 brake area. The machined metal parts are intended to mount to the same points used by the stock disk and caliper so installation is straightforward when mounts match.

The outer ring is engraved with a swirl motif and increased to an 8mm thickness instead of the typical 7mm. Installing these on both front and rear wheels produces a modest track increase that can influence chassis stability through corners and at speed.

Basic RC tools are sufficient for fitment: remove the wheel and hub, replace the disk, secure the caliper to the existing mount points and check torque on the stainless hardware. This product is intended for RC model use only and is not for real vehicles.

Install this kit to tweak braking hardware and marginally widen the wheeltrack for a tangible change in behaviour; confirm compatibility with GT4 TEC 2.0 hubs and recheck fastener torque after initial runs.