TRAXXAS E-MAXX Main Shaft Upgrade 14pcs EMX2037S by GPM  [EMX2037S]

E-MAXX front and rear shaft upgrade

This 14 piece shaft set is an aftermarket replacement tailored for TRAXXAS E-MAXX rigs. The design uses a 6061 T6 aluminium shaft body matched with #45 steel CVD heads to trim rotating weight while maintaining strength where the drives connect. Reduced shaft mass helps decrease drivetrain inertia and can slightly improve battery life and gearbox longevity under frequent acceleration.

Installation notes: front shafts measure 85mm and rear shafts measure 132mm to suit common E-MAXX configurations. Steel CVD ends resist wear at the dogbone and drive cup interface, while the aluminium shaft section reduces overall rotating mass. The kit includes the small hardware often needed for shaft replacement.

Ideal for swapping out worn original shafts or for hobbyists tuning a lighter rotating setup on an E-MAXX. Always verify spline fits and check that the CVD ends engage securely with your existing drive cups.