TRAXXAS E-REVO VXL Front and Rear CVD Set ER2123F/RS by GPM  [ER2123F/RS]

ER2123F/RS product summary

This ER2123F/RS kit provides a 4-piece CVD dogbone set intended as front and rear replacements for TRAXXAS E-REVO VXL models. As an aftermarket upgrade the parts are targeted at improving drivetrain durability and maintaining consistent wheel drive under load.

The components use hardened steel #45 and match the supplied dimensions: a 123mm dogbone length with the shaft diameter increased to 6.5mm from 5.5mm to create a stiffer connection between gearbox output and wheel hubs. That trade-off yields better resistance to bending and wear in demanding use.

Fitment and setup advice: the set suits stock-style output interfaces on E-REVO VXL variants that accept a 6.5mm dogbone diameter; check spline engagement and ensure clearance for drive angle during suspension travel. Because the dogbones are stiffer you may notice small changes in handling, so recheck alignment after fitting.

Install the ER2123F/RS hardened steel set to restore or strengthen driveline durability on TRAXXAS E-REVO VXL cars while retaining stock front and rear mount geometry.