TRAXXAS FUNCO PRO SCALE 2WD Rear Gear Set 32/10T STPS1032T by GPM  [STPS1032T]

TRAXXAS FUNCO PRO SCALE 2WD SAND CAR 20CrMnTi Steel 32/10T Rear Differential Gear set - GPM STPS1032T
Price:
AUD$67.12
Brand:
GPM
Model:
STPS1032T
GTIN:
4894538404715
Condition:
Brand New
Write a review

Durable rear bevel and pinion for 1/6 sand running

The GPM STPS1032T rear differential gear set is a direct-fit RC replacement for the TRAXXAS FUNCO PRO SCALE 2WD 1/6 sand car. It upgrades the stock bevel and pinion to a 32T bevel and 10T pinion in hardened 20CrMnTi steel, featuring spiral teeth and an M1.6 module to limit backlash and provide steadier torque through the rear gearbox.

Install this set when the factory gears show wear or when you need a tougher drivetrain for frequent beach, dune or loose-surface use. Fitting involves reassembling the diff carrier, setting correct gear mesh and applying the right grease and shims so the spiral profile maintains uniform contact.

Packing includes

  • Diff Bevel Gear 32T - 1pcs
  • Rear Pinion Gear 10T - 1pcs

Original Name / Part No:

7791,7792

Compatible Models

  • TRAXXAS 1/6 FUNCO PRO SCALE 2WD SAND CAR 8S-109076-4

This GPM aftermarket set is aimed at improving drivetrain resilience and smoother engagement under sand loads; always verify mesh and lubrication during fitment.

Bearings should be inspected and replaced if worn; fresh bearings help maintain accurate mesh and reduce stress on the new gears, especially after beach use.
Diff grease and fluid choice should suit metal-on-metal contacts; use a grease formulated for gear protection and check after sandy sessions for contamination.
This set keeps the same tooth counts as listed, so ratio remains the same; the main benefit is increased tooth size and material for durability, not speed change.
Use minimal exposed grease, seal openings where possible, and clean and relubricate after each beach session to prevent abrasive wear on the spiral teeth.

Copyright © 2008-2026 rcjaz.com.au All rights reserved