TRAXXAS MAXX Front+Rear Suspension Screw Pin Kit TXMSACC/12 - Stainless Set by GPM  [TXMSACC/12]

TRAXXAS MAXX MONSTER TRUCK Stainless Steel Front+Rear Suspension Screw Pin - 12pc set - GPM TXMSACC/12
Price:
AUD$37.45
Brand:
GPM
Model:
TXMSACC/12
GTIN:
4894538329285
Condition:
Brand New
Write a review
alt="TRAXXAS MAXX MONSTER TRUCK Stainless Steel Front+Rear Suspension Screw Pin - 12pc set - GPM TXMSACC/12" title="TRAXXAS MAXX MONSTER TRUCK Stainless Steel Front+Rear Suspension Screw Pin - 12pc set - GPM TXMSACC/12"
alt="TRAXXAS MAXX MONSTER TRUCK Stainless Steel Front+Rear Suspension Screw Pin - 12pc set - GPM TXMSACC/12" title="TRAXXAS MAXX MONSTER TRUCK Stainless Steel Front+Rear Suspension Screw Pin - 12pc set - GPM TXMSACC/12"
alt="TRAXXAS MAXX MONSTER TRUCK Stainless Steel Front+Rear Suspension Screw Pin - 12pc set - GPM TXMSACC/12" title="TRAXXAS MAXX MONSTER TRUCK Stainless Steel Front+Rear Suspension Screw Pin - 12pc set - GPM TXMSACC/12"

Stainless screw pin kit for monster truck suspension

This 12-piece stainless steel screw pin kit is made for TRAXXAS MAXX monster truck assemblies and fits directly where the original arm mounting pins sit on the model.

The kit contains three lengths to suit specific arm positions: short outer screws for lower arms, medium inner screws for lower arms, and long outer screws for upper arms. Each pin has an internal hex socket to tighten with a hex driver for a secure fit. Stainless construction greatly reduces corrosion risk compared with plated or mild-steel fasteners, while the internal hex helps maintain clamp under the vibration and shock that monster truck running creates.

Note: intended for original arms only; this is an accessory for upkeep and setup rather than for changing arm geometry or full chassis redesigns.

Specifications

  • Item Front and rear suspension screw pin set
  • Material Stainless steel
  • Model Number TXMSACC/12
  • Contents Short outer screws for lower arms - 4 pcs, Medium inner screws for lower arms - 4 pcs, Long outer screws for upper arms - 4 pcs
  • Compatibility Suitable for original arms only

Install these stainless pins when replacing corroded originals or when you want a dependable, vibration-resistant fastening for suspension mounting; check fit and thread engagement and use the correct hex driver to protect the internal recess.

This item is compatible with

  • TRAXXAS-1/10 MAXX MONSTER TRUCK-89076-4
  • MAXX W/WIDEMAXX MONSTER TRUCK-89086-4

Can I run these pins without removing the arm?

You can replace pins in situ if access allows, but removing the arm gives better visibility to confirm thread engagement and prevents cross-threading.

Are the lengths identical to stock parts?

The set includes short, medium, and long pins intended to match the original locations; verify each pin length against the stock parts before final installation.

Will these pins corrode if left in wet conditions?

Stainless steel resists rust far better than plated or mild steel, but after salt or mud exposure rinse and dry the pins to extend service life.

What torque should I use?

Hand-tighten with a hex driver until snug and then apply a small additional turn; avoid overtightening which can damage the internal hex recess.

Copyright © 2008-2026 rcjaz.com.au All rights reserved