TRAXXAS MAXX WIDEMAXX 110mm CVD drive shafts and wheel lock set TXMW110FRS by GPM  [TXMW110FRS]

TRAXXAS MAXX WITH WIDEMAXX MONSTER TRUCK Hard Steel Front & Rear Extend CVD Shaft (110mm) With Aluminum Wheel Lock & Hex Claw - 36pc set - GPM TXMW110FRS
Price:
AUD$171.41
Brand:
GPM
Model:
TXMW110FRS
GTIN:
4894538360950
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="TRAXXAS MAXX WITH WIDEMAXX MONSTER TRUCK Hard Steel Front & Rear Extend CVD Shaft (110mm) With Aluminum Wheel Lock & Hex Claw - 36pc set - GPM TXMW110FRS" title="TRAXXAS MAXX WITH WIDEMAXX MONSTER TRUCK Hard Steel Front & Rear Extend CVD Shaft (110mm) With Aluminum Wheel Lock & Hex Claw - 36pc set - GPM TXMW110FRS"

Extended CVD drive set - kit summary

This replacement and upgrade pack bundles extended 110mm front and rear CVD shafts with wheel locks and hex claws for TRAXXAS MAXX vehicles converted to the WIDEMAXX specification. The components are intended to replace worn drive items or to rebuild transaxle assemblies after wide conversion work, restoring reliable torque transfer to the wheels.

The kit is built for fit and drivetrain reliability rather than visual change. Use it when renewing drive components on a 1/10 4WD MAXX with wide MAXX parts; the items are designed to work with standard MAXX carriers and hub hardware and leave motor and electronics unchanged.

Packing includes

  • Drive Shaft - 4pcs
  • Diff Outdrive - 4pcs
  • Bearing 17*23*4 - 4pcs
  • Bearing 8*16*5 - 4pcs
  • Screw Shaft M4*2.5*17 - 4pcs
  • Set Screws M4*5 - 4pcs
  • Wheel Lock - 4pcs
  • Wheel Hex Claw - 4pcs
  • Steel Pin 3x15 - 4pcs

Original Name / Part No:

8996X

Compatible Models

  • TRAXXAS-1/10 4WD MAXX W/WIDE MAXX MONSTER TRUCK-89086-4

A compact 36 piece spare parts kit to streamline drivetrain servicing and component swaps on 1/10 TRAXXAS MAXX WIDEMAXX monster truck builds.

Do these shafts require new hubs or carriers?

They are matched to the wide MAXX configuration in the compatibility box; most installs will use existing wide hubs and carriers but confirm spline and length fit before tightening components.

What should I check after the first run?

Check wheel hexes, set screws and pin retention, re-torque fasteners as needed, and inspect bearings for correct seating after initial track or trail use.

Can these be fitted alongside aftermarket axles?

Compatibility depends on axle and hub dimensions; compare outdrive and hub interfaces to ensure the kit's diff outdrives and hex claws match your aftermarket parts.

Are spare bearings included for both ends?

Yes, the kit includes both 17x23x4 and 8x16x5 bearings to cover the typical bearing locations used in the diff outdrives and shaft assemblies.

Copyright © 2008-2026 rcjaz.com.au All rights reserved