TRAXXAS Revo Sandwich Rear Lower Arm Right Side TRV056RS by GPM  [TRV056RS]

TRAXXAS Revo /Revo 3.3 Alloy Rear Lower Arm (Sandwich Design With Screws+Pins)-1pc set (For Right Side) - GPM TRV056RS
Price:
AUD$19.69
Brand:
GPM
Model:
TRV056RS
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Right-side alloy lower arm for TRAXXAS Revo

The TRV056RS alloy rear lower arm is manufactured for TRAXXAS Revo platforms that use the standard lower arm mount pattern. It is supplied as a single right-side sandwich assembly and arrives with the screws and pins needed to fasten the plates.

Functionally the rear lower arm locates the hub assembly and transfers suspension loads into the chassis. The stacked alloy plate sandwich provides a sturdy replacement geometry that can be fitted quickly during maintenance or setup work using the included hardware.

Installation guidance: sold as one right-side arm with the listed assembly hardware; confirm correct orientation prior to tightening. Fitment follows the factory mounting points on TRAXXAS Revo and Revo 3.3 chassis. Use standard hand tools, torque fasteners appropriately, and recheck suspension alignment after installation.

Can this be used for competition setups?

The arm is a durable aftermarket option suitable for tuning and repair; verify compatibility with your specific chassis and setup before using in competition.

Are bearings or bushings affected by this swap?

This arm uses the same mounting points as stock units, so bearings and bushings remain unchanged; inspect suspension pivots during replacement.

How do I check alignment after fitting?

After fitting, measure toe and camber, confirm suspension travel is free, and perform a short test drive to detect any handling changes.

Copyright © 2008-2026 rcjaz.com.au All rights reserved