Traxxas Revo Upgrade Spur 36T Delrin RE-028 by 3Racing  [RE-028]

Traxxas Revo Delrin Spur Gear 36T - 3RACING RE-028
Price:
AUD$9.70
Brand:
3Racing
Model:
RE-028
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Delrin 36T Spur for Revo Transmissions

Supplied as a direct swap or upgrade, this 36T Delrin spur gear fits Traxxas Revo spur positions where a low-friction material is preferred for regular servicing or setup tweaks. The gear is aimed at hobbyists tuning drivetrains or replacing worn spurs.

Delrin (acetal) provides stable dimensions and lower sliding friction than many commodity plastics. When installed the spur transfers motor torque through the gearbox, so correct mesh, bearings and shaft alignment are vital to extend component life.

Fitment advice: clean the mating faces, check backlash and make sure the spur locates properly on the Revo hub or mounting plate. After installation, run a short, low-load test and listen for excessive noise before normal use.

Do I need to change the pinion when fitting this spur?

Not usually, but verify gear mesh with your existing pinion and adjust if necessary to avoid binding or excessive play.

How should I set mesh on installation?

Set a small, even gap using a shim or paper method, tighten hardware evenly, then check for smooth rotation under manual spin.

Is Delrin suitable for high-power setups?

Delrin can work well in many setups but always confirm gear mesh, bearings and motor load; for extreme power you may consider metal alternatives.

Copyright © 2008-2026 rcjaz.com.au All rights reserved