TRAXXAS Rustler VXL Front Bulk Alloy RUS008 for tuning by GPM  [RUS008]

Front arm bulkhead upgrade for Rustler VXL

This aftermarket alloy front arm bulk is intended for TRAXXAS 1/10 Rustler VXL models and fits as a direct swap for the factory plastic bulkheads. The part provides a rigid pivot point that affects steering geometry, toe control and camber under load.

Installation is a routine service task: remove the front suspension, swap the bulk units, inspect pin and bearing seats for alignment and reassemble using thread locker where needed. Standard hex tools and a basic spanner set are normally sufficient, but always verify fit on your chassis before completing the job.

Upgrading to an alloy front bulk reduces flex at the pivot and helps produce a more consistent steering response when adjusting handling. This part is aimed at RC maintenance and tuning applications and should be used on 1/10 Rustler VXL models as listed.

Replace tired front bulkheads with the RUS008 alloy bulk to stiffen the pivot and support suspension setup changes on your Rustler VXL.