TRAXXAS Slash 4X4 7075 Alloy Front Tie Rods With Stabilizer SLA049LCGN by GPM  [SLA049LCGN]

High strength 7075 tie rods for Slash 4X4 steering

This front steering tie rod assembly is an aftermarket hop-up created to match the TRAXXAS Slash 4X4 C-hub and steering mounts. Constructed from 7075 aluminium, the parts prioritise tensile strength and reduced mass versus softer alloys while preserving the steering geometry used in standard setups.

The assembly features an integrated stabilizer and a triangular reinforcement to boost lateral stiffness at the knuckle without removing required suspension compliance. The tie rod is adjustable and uses a counter-clockwise threaded fitting on one end to secure rod ends and permit precise toe tuning.

Primary installation points are the C-hub tops, both front gearbox side mounts and the central stabilizer support on the chassis. Use this part where you want crisper steering feedback and repeatable adjustments during setup sessions.

Fit the 7075 alloy tie rods and stabilizer to reduce unwanted steering flex and allow fine toe adjustments on Slash 4X4 rigs; confirm thread orientation before final assembly.