TRAXXAS SLASH 4X4 Front C Hub King Pin 4-Pack SLA019AP by GPM  [SLA019AP]

Stainless pivot pins for TRAXXAS SLASH front assembly

Sold as a set of four, these stainless steel king pins are intended to replace worn pivot pins in the front C hubs of TRAXXAS SLASH 4X4 units. The parts provide a simple, direct swap to revive hub pivot contact without major changes to the suspension layout.

Routine fitting requires basic hub service: remove wheel and hub, push out the old pin, install the stainless pin into the hub bore and refit the factory retaining clips. The set services both left and right front hubs to get you back on track in one session.

Renewing the pivot surfaces reduces steering freeplay and helps maintain repeatable front-end setup when tuning or after prolonged use has caused metal wear at the pivot points.