TRAXXAS Slash 4X4 Low-CG Gear Adapter Aluminium 32-Pitch 54T Spur 18T Pinion SLA155418TLG by GPM  [SLA155418TLG]

Aluminium adapter matched to hardened 32-pitch steel gears

This gear adapter and 32-pitch gear set has been made for the TRAXXAS Slash 4X4 low-CG 68086-21 transmission. The kit pairs a low-mass aluminium adapter with hardened steel 54T spur and 18T pinion gears to promote steady torque transfer through the drivetrain.

Design and materials overview: the aluminium adapter reduces weight at the gearbox interface to help lower the centre of gravity, while the hardened steel spur and pinion provide wear resistance under repeated loading. The 32-pitch form factor corresponds to the Slash 4X4 low-CG transmission for this model.

Setup and run-in pointers: after installing the adapter and gears, set the gear mesh and check backlash, secure the pinion set screw, and turn the assembly to confirm there is no binding. Recheck mesh and bearings after a few short runs to allow components to seat properly and to optimise noise and drivetrain efficiency.

Standard gear ratio table

• 54T with 15T = 1:3.600
• 54T with 16T = 1:3.375
• 54T with 17T = 1:3.176
• 54T with 18T = 1:3.000
• 54T with 19T = 1:2.842
• 54T with 20T = 1:2.700

Fit this aluminium low-CG adapter with hardened steel 32-pitch gears when you need a lower gearbox centre of gravity and long-wearing steel gearing for consistent power delivery on the Slash 4X4 low-CG 68086-21 platform.