TRAXXAS Slash 4x4 Precision Turnbuckles for Steering SSLA160ST by GPM  [SSLA160ST]

Precision turnbuckles for Slash 4x4

This 3pcs set of spring steel turnbuckles with alloy ball ends is intended for TRAXXAS Slash 4x4 1/10 models as a direct-fit replacement or durable upgrade for steering and suspension linkages. The spring steel construction limits shaft bending while the alloy ball ends keep a steady ball-socket interface for predictable steering response.

Installation is simple: remove the worn link, respect thread orientation, and screw the new turnbuckle into the existing ball cup until you reach the required length and toe settings. Keep factory measurements handy and make small adjustments to retain correct wheel alignment.

For tuning, these turnbuckles give fine length control over toe and steering angle and create a robust connection that better withstands impacts. Replace worn hardware or use them when you want repeatable handling changes while testing setups.

A pragmatic hop-up to maintain steering geometry and front-end stability on Slash 4x4 platforms, supplied as three pieces for targeted repairs or upgrades.